BEA SKS650-228C, Руководство пользователя

Страница: 13 / 51

EN - 13
Device-specific additional instructions for nailer
SKS650-228C
4 Filling the magazine
•
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
•
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position
(Chap. 3): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger
and/or release protection.
•
Press the latch button 1 and push the magazine cover 2 to
the rear. Insert the round head nails with the tips at the
bottom into the magazine 3. Then push the magazine cover
2 forward
.
5 Adjusting drive-in depth
•
Reduce pneumatic operating pressure as far as possible to
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
•
Disconnect the tool from the compressed air supply. Turn
adjustment knob 1 for deeper countersunk nails clockwise. Turn
anti-clockwise to lower the nails less deeply.
6 Removing stuck fasteners from the driving channel
•
Disconnect the tool from the compressed air supply. Open the magazine as described in chapter 4 and
remove the brads. Then reconnect the tool to the compressed air supply and refill it with brads
.
7 EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------ -----------------------------------------------------------
Dr. Jörg Dalhöfer, CEO Joachim Bauer, Documentation responsible