6
2
1
4
5
1
2
1
2
1
2
1
1
2
1
2
1
2
1
1
1
8
1
E1
E2
E4
E5
E8
1
3
1
3
1
2
TROUBLESHOOTING
ORANGE LED flashes 1 x.
ORANGE LED flashes 2 x.
ORANGE LED flashes 4 x.
ORANGE LED is on.
RED LED flashes
quickly after an
assisted setup.
RED LED lights up
sporadically.
the LED is off.
the reaction of the door
does not correspond to
the LED-signal.
the sensor signals
an internal fault.
the power supply is too
low or too high.
the sensor receives
not enough IR-energy.
the sensor encounters
a memory problem.
the sensor vibrates.
the sensor sees the door
during the assisted setup.
the sensor sees the door.
the sensor is disturbed by
external conditions.
Check power supply
.
Check wiring.
Cut and restore power supply.
If orange LED lights up again, replace sensor.
Check CAN communication.
Increase the IR-immunity filter to value 3 (< 2,8 m).
Select presetting 2 or 3.
Launch an assisted setup and adjust the IR angle.
Replace sensor.
ORANGE LED flashes 5 x.
the sensor receives
too much IR-energy.
ORANGE LED flashes 8 x.
IR power emitter is faulty.
Replace sensor.
the remote control
does not react.
Enter the right password. If you forgot the code, cut
and restore the power supply to access the sensor
without entering a password during 1 minute.
the sensor is protected by a
password.
the sensor is disturbed by
external elements.
Eliminate the cause of disturbance (lamps, rain cover,
door controller housing properly grounded).
Move the IR-curtains away from the door.
Install the sensor as close to the door as possible.
If needed, use a bracket accessory.
Launch a new assisted setup.
Decrease the angle of the IR-curtains.
Increase the IR-immunity filter (values >2.8 m).
Deactivate 1 curtain.
Slightly increase the angle of the IR-curtains.
Check if the sensor is fastened firmly.
Check position of cable and cover.
Check power supply
.
Check wiring.
The ORANGE LED flashes
quickly.
DIP-switch setting awaiting
confirmation.
Cut and restore power to confirm the DIP-switch setting
