75.5159.09 20090115
8/10
3.
Use the chart below as an aide for the manual programming procedure.
5
Manual Setup Of The Sensor – continued
REQUIRED: If the IR frequency has been manually changed, to prevent the sensors from being in permanent
detection, momentarily depress the right program button to launch an assisted setup.
High mounting height
(>10’)
If the sensor is installed higher than 10’ above the floor, make sure to use the narrow prism
(See Ch. 3).
Rain/Snow
If the sensor is exposed to rain or snow, use the URC (Universal Rain protection Cover)
Set the sensor to immunity level 2 or 3 to increase the immunity of the sensor.
Setup
Assisted Setup (~14sec)
Sensor checks the influence of the door leaves to the IR
curtains (performs a door open/door close cycle)
Standard Setup (~4sec)
Sensor only learns its environment
After adjusting the sensor for the first time, it is required to launch an ‘Assisted Setup’ (See Ch. 4).
If the IR sensor module ‘sees’ the door movement, move the curtains out of the door leaf.
Access Code
The access code is recommended to set sensors close to each other with remote control. The access code can
be composed of 1 to 4 digits (factory values or no access code : 0 or 0000). No code is required to unlock during
the first minute after powering. To enter a lock code, simply press the Lock key, followed by a lock code. If lock code is
less than 4 digits, the lock key must be pressed a second time following the last digit of the code (See Pg. 5).
Overlapping
IR-curtains
Overlapping IR-curtains from sensors installed side-by-side may cause disturbances due to crosstalk
(interferences). Select different frequencies on each sensor to avoid crosstalk (See Setting ‘Installation
Configuration’ on Pg.6).
Attention: avoid curtains that are overlapping by more than 12” (at 7’ mounting height, using the wide prism).
PARAMETER NUMBER
(altered by the right button and
confirmed by
RED LED
)
PARAMETER
VALUES
(altered by the
left button and
confirmed by
GREEN LED
)
DEFAULT
VALUE
1 Not
Used
-
-
2
Relay hold time
-
-
3 Output
configuration
1-4
4
4
Auto-learn
presence sensing
0-9
0 = IRIS
9 = IRIS-I
5 Not
Used
-
-
6 Not
Used
-
-
7 IR
Immunity 1-3
2
8
Not Used
-
-
9 Not
Used
-
-
10 IR
curtain
1-2
2
11 Not
Used
-
-
12
Height & Frequency
1, 3
1
13 Not
Used
-
-
14
Door control function
1-3
1
15 Not
Used
-
-
5 Helpful
Hints
