75.5351.02 EN 20080317 (75.5350)
Page 2 of 7
To remove or to
insert the cable:
•
Unscrew the retaining
nut;
•
Pass the cable through
the grommet and the
retaining nut.
•
Tighten the retaining nut.
Opening the sensor
Closing the sensor
•
Loosen the retaining nut
until the cable slides easily into the
grommet;
•
Partially unscrew the 2 front cover
screws;
•
Pull out the front cover with the 2
front cover screws.
•
Connect the quick disconnect terminal block to the main
electronic circuit;
•
Slide the main electronic circuit into the 2 housing slot
guides;
•
Gently push the front cover and make sure that the external
housing is properly seated (front cover must be flush with
housing).
•
Screw the 2 front cover screws and tighten the retaining nut.
Ceiling Mounting
Wall Mounting
Remark:
The bold-type values give the minimum distance required to be able to fully adjust the sensor.
•
Check that both locking collar
are at the same angle;
•
Align the bracket slot to the
locking collar guide as shown.
WIRING
OPENING AND
CLOSING THE
SENSOR
SENSOR
DIMENSIONS
AND
MOUNTING
2.5 in
5 in
6.25 in
6.
5 i
n
6 i
n
3 in
5.5 in
6 in
5 in
6.25 in
BRACKET
MOUNTING
US Wire Color:
Red Black White Green Yellow
12-24 VAC/DC COM NO NC
European Wire Color:
Brown Green White Yellow Gray
