BEA 14412430, Инструкция по эксплуатации

Страница: 7 / 12

- 6 -
Mounting the accessories
26 4
Long handle 4
27 29
28
30
Important!!!
If the long handle is not assembled, connector A (27) must always be
open and connector B (28) must always be closed by the plug (26)!
Edge guide:
12
11
31
Festool rail guide set:

Unscrew and detach carrying wheels with AF 15mm wrench.

Fix the festool rail guide set
32
33
With the Festool rail guide the skater can be pushed or pulled through a Festool rail. It is
possible by the grooves (33) to depart two webs at a distance of 20 mm, without changing the
position of the Festool rail.
Before attaching the long handle
disconnect tool from the air supply.
Remove the plug (26) from the air
connection B (28) and store safely in (30)
on the long handle support.
Insert the long handle into the long handle
support (4) until the holding bolt (29) snaps
in.
Connect the black hose to the connector A
(27) and the blue hose to the connector B
(28)
Loosen butterfly screw (12) and take out the
protector (11).
Insert the edge guide into the slot.
Set the distance between the edge guide and
the centre of the nose piece with the help of the
scale (31). Tighten the butterfly screw again.
The edge guide can be used to guide the skater
at the edge of the board or at a table track