Page 2 of 2
75.5029 V1 Oct 2005
PROGRAMMING
PROCEDURES
COMPANY
CONTACT
1.
Remove lower access cover from the transmitter housing. Helpful Hint: Use
the enclosed metal clip as a pry tool for this step.
2.
Insure that a 9-volt battery is installed and is working. Simply press a button
and the red LED should illuminate on the transmitter.
3.
There are two sets of dipswitches - both have 10 positions. As viewed
properly, the left side is set “A”, and the right side is set “B”.
4.
Dipswitch set “A” corresponds to buttons 1 and 2. Dipswitch “B” corresponds
to buttons 3 and 4.
5.
To begin programming, start with button #1 and Receiver #1. Follow the
outline below, step by step.
PROGRAM TRANSMITTER / RECEIVER 1:
Set code on receiver 1 using ONLY positions 1 though 8.
Set code (using only 1 through 8) on transmitter dipswitch set A to
match receiver 1.
Set the 9
th
position on the receiver and the transmitter to the ON (closed) position.
Set the 10
th
position on the receiver and the transmitter to the OFF (open) position.
PROGRAM TRANSMITTER / RECEIVER 2:
Set code on receiver 2 using ONLY positions 1 though 8, to match dipswitch set A on transmitter
Set the 9
th
position on the receiver to the ON (closed) position.
Set the 10
th
position on the receiver to the ON (closed) position.
Keep position 10 on the transmitter for dipswitch A in the OFF (open) position as set in previous
steps.
PROGRAM TRANSMITTER / RECEIVER 3:
Set code on receiver 3 using ONLY positions 1 though 8.
Set code (using only 1 through 8) on transmitter dipswitch set B to match receiver 3.
Set the 9
th
position on the receiver and the transmitter to the OFF (open) position.
Set the 10
th
position on the receiver and the transmitter to the OFF (open) position.
PROGRAM TRANSMITTER / RECEIVER 4:
Set code on receiver 4 using ONLY positions 1 though 8, to match dipswitch set B on transmitter
Set the 9
th
position on the receiver to the OFF (open) position.
Set the 10
th
position on the receiver to the ON (closed) position.
Keep position 9 & 10 on the transmitter for dipswitch B in the OFF (open) position as set in the
previous step.
6.
Power up and test system to insure proper operation. Refer to the User’s Guide for the 300 MHz receiver if
instruction is required for powering.
7.
Each button on the transmitter should trigger only the respective receiver: button 1 to trigger receiver 1
only, button 2 to trigger receiver 2 only, etc.
If after troubleshooting a problem, a satisfactory solution cannot be achieved, please call B.E.A., Inc.
for further assistance during
Eastern Standard Time at 1-800-523-2462 from 8am - 5pm.
For after-hours, call East Coast: 1-866-836-1863 or 1-800-407-4545 / Mid-West: 1-888-308-8843 /
West Coast: 1-888-419-2564.
DO NOT leave any problem unresolved
. If you must wait for the following
workday to call B.E.A., leave the door inoperable until satisfactory repairs can be made.
NEVER sacrifice the safe operation of the automatic door or gate for an incomplete solution.
Web: www.beasensors.com
B
A
ON
(closed)
OFF
(open)
2
1
4
3