BE HLTT16, Руководство пользователя

Страница: 14 / 44

14
Operation
CONNECTING HEATER TO LP CYLINDER
Be sure to read and understand all of the Safety Information in this
manual before connecting the heater to the LP cylinder. Installation must
conform to local codes and with the Standard for the Storage and Han-
dling of Liquefied Petroleum Gases and ANSI/NFPA 58
Inspect the hose and regulator prior to each use of the heater. If there is
excessive abrasion or wear, or if the hose is cut, replace it with the proper
assembly shown in the parts list prior to using the heater.
Model HLTT16
1. Be sure that the control knob on the regulator is in the “OFF”
position.
2. Line up the threads on the Fuel Connector Nut with the threads
on the LP cylinder valve. Turn Fuel Connector Nut counter-
clockwise to tighten. Use a wrench to fully tighten the nut, being
careful not to overtighten.
3. Slowly open the LP cylinder valve.
4. Check all connections for leaks using a 50/50 mixture of dish
soap and water. Any bubbles appearing show a leak. Remove
and reconnect the Connector Nut to the valve.
Model HLTT32
1. Be sure that the control knob on the regulator is in the “OFF”
position.
2. Line up the slots in the tank collar bracket with the tank collar
ring and slide into place. Be sure the mounting knob is to the
outside, and tighten.
3. Line up the threads on the Fuel Connector Nut with the threads
on the LP cylinder valve. Turn Fuel Connector Nut counter-
clockwise to tighten. Use a wrench to fully tighten the nut, being
careful not to overtighten.
4. Slowly open the LP cylinder valve.
5. Check all connections for leaks using a 50/50 mixture of dish
soap and water. Any bubbles appearing show a leak. Remove
and reconnect the Connector Nut to the valve.
6. Do not direct heater discharge towards any propane cylinder
located within 20 feet of the heater.
OPERATION