Attach the log tray assemblies to the brackets on the
two sides of the machine
. (
Fig. 3)
Screw on the control handle lever.
(Fig.3)
Remove the white transportation seal plug from the oil filling
port, and then insert the dipstick with a breather cap into the
oil filling port firmly.
(Fig. 3)
•
Fill the tank with universal hydraulic oil (3210W AW
hydraulic fluid). (
Fig. 4)
NOTE:
a)
Dispose of the packing in an environmental friendly manner. Take to a proper collecting point.
b)
If you notice transport damage while unpacking, notify your supplier immediately. Don’t operate the
machine.
c)
Read, understand and follow all safety instructions in this manual and labels on the equipment carefully.
d)
Keep the manual in a safe place for future and regular reference.
e)
Ensure the machine is disconnected from power supply while assembling.
2.
Preparation before operating
•
Put the machine on the level surface.
•
Always block the wheels to prevent movement of the log splitter while in operation.
•
Oil the wedge and upper side of the tank, which would make your operating more smoothly.
•
Check all nuts, bolts and hydraulic fittings are tight to be sure the equipment is in safe working condition.
•
Make sure your outlet, mains voltage and frequency match the data stated on the model
plate (or “Technical specifications” in this manual).
•
The power supply for this splitter must have the protection device of under-voltage, over-voltage, circuit
breaker with a residual current device (RCD) which maximum residual current rated at 0.03A.
•
Check the switch, power cable and plug are not damaged (no cracks, etc.) to exclude the risk of electric
shock and circuit short.
•
Check all safe shields to be sure they are in the proper position.
•
Wear non-slip safety shoes, safety goggles, safety gloves and suitable work clothing. Never wear jewelry,
necktie and other loose clothing.
•
Logs should be cut with square ends and permissible dimensions in advance within the limited capacity .
Uneven log (e.g. knotted, curved, etc) should not be cut.
Note:
a)
Make sure the power cable is unplugged while adjusting.
b)
After adjusting, take away the accessories on or around the unit before switching on.
c)
Ensure the motor properly earthed or apply protection device.
d)
Use only rubber-jacketed cable of sufficient lead cross section as extension cable. Never use an
extension cord longer than 25 feet. Cord gage must be 14 or lower.
e)
Keep away from inflammable liquids or gases before starting the machine.
f)
Hydraulic oil is flammable and can explode. Always take a Class B fire extinguisher with you when
operating this log splitter in dry area as a precautionary measure against possible flying sparks.
g)
Always check the oil level of the hydraulic reservoir before operation. Operating the log splitter without an
adequate oil supply will cause severe damage to the pump.
h)
Keep handles free of oil, grease and resin.
i)
Before starting work, hydraulic pipes and hoses shall be inspected and the stopping devices should be
tested.
j)
Selection and preparation of a suitable working are free from obstructions.
8
1)
Remove the dipstick.
2)
Fill the tank at least the range marked on the dipstick.
3)
After filling, insert the dipstick.
4)
Operate the unit fully extended for several times to repel
out the air trapped in the tank.
Fig. 3
Fig. 4
