12
BE-WCGR4XXX USER MANUAL
Operation Location
1. Select an area with firm, level ground, covered by dirt or grass.
2. Do not operate on wet or slick surfaces, or near bystanders.
3. Locate and organize the materials to be processed so that you don’t have to walk in front of the inlet or
discharge openings, and so you have adequate room to work safely.
Adding Oil
Refer to engine manual for information on adding oil.
DANGER
1. THE EXHAUST FROM THIS PRODUCT CONTAINS CARBON MONOXIDE GAS. CARBON MONOXIDE
IS A COLORLESS, ORDERLESS AND TASTELESS GAS THAT CAN CAUSE DIZZINESS, NAUSEA,
UNCONSCIOUSNESS OR EVEN BRAIN DAMAGE AND DEATH IF INHALED FOR PROLONGED PERIODS.
2. OPERATE THE UNIT OUTDOORS IN A WELL VENTILATED LOCATION ONLY. KEEP CHILDREN, PETS
AND BYSTANDERS AWAY.
3. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR DEATH
.
WARNING
1. GASOLINE IS HIGHLY FLAMMABLE AND MUST BE HANDLED WITH CARE. NEVER FILL THE TANK
WHEN THE ENGINE IS STILL HOT FROM RECENT OPERATION.
2. DO NOT ALLOW OPEN FLAME, SMOKING OR MATCHES IN THE AREA. AVOID OVER-FILLING AND
WIPE UP ANY SPILLS.
WARNING:
TO AVOID SERIOUS PERSONAL INJURY FROM ROTATING CUTTING BLADES, KEEP
HANDS OUT OF INLET WHILE MACHINE IS RUNNING.
WARNING:
DO NOT USE GASOLINE CONTAINING METHANOL, GASOHOL CONTAINING MORE THAN
10% ETHANOL, GASOLINE ADDITIVES OR WHITE GAS BECAUSE ENGINE/FUEL SYSTEM DAMAGE
COULD RESULT.
IMPORTANT:
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU MUST ADD ENGINE OIL
BEFORE STARTING ENGINE.
Adding Fuel
To add fuel:
1. Remove the fuel cap.
2. Fill the tank. Do not overfill. Leave room in the tank for fuel expansion. Refer to your engine manual for
specific fuel recommendations.
3. Install and hand tighten the fuel cap.
Starting the Engine
1. See engine manual for starting up instructions.
2. Ensure engine is running full throttle before beginning chipping operation. On some engines, the throttle
may not be adjustable.
Stopping the Engine
1. See engine manual for shut down procedure.
2. Stopping the engine is the only way to stop the rotor from turning. With engines equipped with an adjust-
able throttle, move the throttle to the SLOW position and wait for engine to be running a slow RPM. Then
switch to STOP ENGINE as shown in the engine manual.
