4
BE-P2BFK USER MANUAL
1. TECHNICAL DATA
1.1 INTRODUCTION
This handbook contains the use and maintenance instructions with a list of the spare parts of the mould
board plough.
This M.B. plough is equipped with heavy-duty box frame specially designed for deep ploughing/land
preparation of rough soil. It is designed to work in all types of soil for basic functions such as soil breaking,
soil raising and soil turning. It can handle the toughest ploughing job with outstanding penetration
performance.
Regular and satisfactory operations together with economic and long lasting use of the implement depend
on the compliance with instructions given in this handbook.
Compliance with the instructions in this handbook is also important since Manufacturer declines all and
every responsibility for damage to persons or property caused by negligence and failure to comply with
these instructions.
2. USAGE INSTRUCTIONS
2.1 BEFORE USE
Before mounting the M.B. plough make sure that all nuts and bolts are properly secured.
2.2 ATTACHING THE PLOUGH TO THE TRACTOR
1. Place the plough duly leveled on even land.
2. Bring the tractor backwards to the plough (don’t drag the plough towards the tractor).
3. Attach the left arm of the tractor to the plough first.
4. Attach the central arm to the plough. To attach, turn the screws on both sides to an equal length. If the
arm is too short or too long, turn the screw to adjust both simultaneously until aligned with the hole on
the central arm.
5. To attach the lower right arm, turn the screw until the mounting pin is at the same level as the hole on the
tractor arm. If the gap between hole and mounting pin is too close or too distant, turn the control arm in
or pull it away to an appropriate distance respectively. You may have to adjust both height and distance
at the same time.
When the hole at tractor arm and mounting pin are at even levels, insert the pin in the hole and lock it
with the lynch pin.
6. After attaching the plough lift it and adjust the control arm parallel to the ground.
When you look from both rear or sideways, the points should all be touching the ground uniformly.
2.3 NOTE:
The plough will work best when the right wheel of the tractor is inside the previously ploughed furrow i.e.,
when the plough will be in one of the furrow. Readjust the plough alignments if need be. The first bar point
will pick up a lot or a little soil depending on how far or near the rear wheel is to the furrow respectively
