11
EKF Series 300/500/600
GB
Inserting the tool
WARNING
Risk of injury!
►
Do not use damaged, soiled or worn
tools.
►
Change tools only when the machine
is switched off and at a standstill. Pull
the plug out of the mains socket.
►
After inserting, check that the tool is
engaged securely.
►
Only use tools, adapter and accesso-
ries that match the machine.
Proceed as follows to use the milling cutter:
Loosen the side clamping screw (3,
fig. 4).
Unscrew the housing from the motor.
Screw in the desired milling cutter.
Screw on the housing again.
Tight the clamping screw.
Setting the speed
NOTE
►
This function is only available for ma-
chines of the EKF Series 500/600.
►
The speed can be reduced for
processing stainless steel as well as
hard and stiff materials.
Set the speed by turning the speed
regulator (12, fig. 3) to the required
value.
Preparing
