BDITEST.COM
1. Connect the lug on the red cable from the bonder handle to the smaller terminal. Then install and hand-tighten the
wing nut again. Do not over tighten.
2. Line up the 3-pin connector from the handle with the receptacle on the panel. Twist the barrel of the connector to
secure it.
3. Use either cable with the magnetic clamp or the mechanical clamp. Connect clamp to bare, clean steel. To activate
the magnetic clamp, place it on a bare, clean steel surface then turn the switch to ON.
4. Insert the battery pack into the handle in the orientation shown in the drawing below until the pack snaps into place.
Charge the battery pack before use.
