4
assembly
instructions
bdiusa
.
com
customerservice
@
bdiusa
.
com
Thank you for choosing BDI.
Your BDI home theater cabinet is engineered to include a range of adjustments. Please read and retain this
guide so that you can fully enjoy the look and use of your cabinet for years to come.
Unless manual leveling is required or you wish to prevent the cabinet from rolling, you may prefer to keep the
cabinet’s levelers up and off the floor. This allows easier cabinet movement for greater access to rear panels
and wire-management, and permits easier cleaning/vacuuming underneath the cabinet.
By following the steps in this guide, you can be sure that your BDI cabinet is in optimum tune and adjustment. If
you need additional assistance, contact BDI at [email protected].
Fine tuning your BDI Home Theater Furniture
After unpacking and assembling your cabinet, inspect it to be sure that it is sitting level on the floor, that all
doors appear level, and that they open and close freely without rubbing or binding.
Due to uneven floors or perhaps gentle jostling during shipment, your BDI cabinet may not appear to be in
perfect alignment when first assembled or when loaded with heavier electronic equipment. Such alignment
issues are usually minimized or eliminated with only a few minor adjustments.
STEP 1 - Level the cabinet (if needed)
Levelers are integrated into each leg assembly and are accessed from outside
the cabinet. If your floor is uneven, you may extend one or more levelers (with the
provided
Leveler Wrench (C)
) to attain a level, stable cabinet placement. Turning
the leveler clockwise will extend the leveler; turning it counter-clockwise will
retract it.
STEP 2 - Adjust Door Hinges (if needed)
The doors on your cabinet should be evenly spaced and the doors should open and close freely without rubbing
against the door frame.
If the cabinet’s doors appear out of alignment,
this condition can be corrected with minor
adjustment to the European hinges on each
door.
Because these hinges are infinitely adjustable,
adjusting one hinge element can sometimes
cause the need for adjustments to other
elements. But with a few adjustments, you can
modify the orientation of the cabinet doors to
make sure that they hang perfectly within your
cabinet.
Use a Phillips screwdriver to adjust Novia’s door hinges:
• By adjusting
Screw 1
, the door will move LEFT or RIGHT within the frame. Make minor adjustments at
both top and bottom hinges for best results.
• By adjusting
Screw(s) 2
, the door will move UP or DOWN within the frame (the top and bottom
hinges must be adjusted the same degree).
NOTE:
If your hinges have a Slotted Mounting Plate (as shown in Figure 2): Loosen
Screws 2
one
complete turn, raise or lower door, then hold in position while tightening
Screws 2
(on both hinges).
• By adjusting
Screw 3
the entire door will move IN or OUT, opening or closing the gap between the
door frame and cabinet. (This screw rarely needs adjustment.)
INCORRECT!
Door is
out of alignment with
the rest of the unit.
CORRECT!
Door is
sitting squarely and
evenly spaced on tops
and sides.
1.
2.
3.
3.
1.
2.*
2.*
2.
2.
3.
1.
1.
Figure 2
Figure 1
3.
