Pg. 7
HEATER/FIREPLACE OPERATION
• This appliance has a safety-cut off that will engage if the fireplace overheats. The fireplace will NOT
automatically reset for safety reasons. To reset the appliance, unplug the unit for 15 minutes and then
plug it back in.
• This appliance can be controlled by the panel on the unit or the remote.
• Do not press the buttons more than once in two seconds; it takes some time for the fireplace to respond.
1
2
3
4
1. ON/OFF: Turn the heating/display effect on and off.
2. DIMMER: Controls the brightness levels. Press to cycle through five brightness levels and the OFF
setting. Press and hold for three seconds to switch between three flame colors – orange, blue, and
red.
3. HEAT 1/ HEAT 2: Controls the heating level. Press to cycle through the low setting (750W), high
setting (1500W), and the OFF setting.
4. STANDBY SWITCH: Press to toggle standby on/off. This must be switched on to use the
heater/fireplace. It is located on the right side of the fireplace.
REMOTE CONTROL OPERATION
The remote has a 3V CR2025 lithium cell battery included. Remove the slip between the battery and
contacts before operating the remote.
ON/OFF
COLOR – Change flame color
DIMMER – Adjust dimmer settings
HEAT – Adjust heat settings
REPLACING BATTERIES
• Press the release and slide open the back panel of the remote.
• Remove the battery.
• Insert a brand new CR2025 battery, ensuring the “+” and “-“ signs are in the correct order.
• Replace back panel.
ON/OFF
DIMMER
HEAT1/
HEAT2
