360° EVERSION
PHOTO & VIDEO
RESTART
• Once you have a general understanding of how to
control the quadcopter you can activate the
360-degree eversion function.
• Fly the quadcopter at a minimum height of 9 feet.
• Press the 360-degree eversion button located on
the top right of the remote control, then move the
right control lever in the direction you wish to flip.
ON
• Turn on the quadcopter. If the lights are flashing green, this means that the
camera is functional and has a SD card.
• To take a photo, push the photo/video button up. The lights will flash red and
a beep will emit from the remote control to indicate a successful photo.
• To record video, push the photo/video button down. The lights will flash red
to indicate that the video is recording. Push the photo/video button down
again to stop recording.
Turn on the remote control and the quadcopter.
Push the left control
lever (throttle) to the
highest position, and
then pull it back to the
lowest position.
Hold the left and right
control levers in the lower
right corner position for 2 to
3 seconds. The lights will
flash normally to indicate a
successful restart.
ON
ON
ON
Pg. 5
• Remove the battery from the quadcopter before charging.
• Charge the battery in a dry and ventilated location away from children.
• Let the the battery cool down before charging. Charging a warm battery could cause swelling and
result in a fire hazard. If the battery becomes swollen, replace it immediately.
• Only use the provided USB charging cable.
Turn the quadcopter off and
open the battery cover.
Pull the battery wire out of the
power port.
Connect the battery to the USB
charging cable. Make sure that the
ports are securely attached. Plug
the USB charging cable into an
outlet or computer to charge.
CHARGE TIME:
1.5 hours |
FLIGHT TIME:
6 to 8 minutes
CHARGING THE BATTERY
