We would like to thank all users for trusting BCN3D, for helping us to reach our
dreams and to create a better product every day.
Unboxing
Once the upper box is removed, follow these instructions:
1. Remove the top protective foams.
2. Cut the white strap around the bottom box
A
and pull the plastic bag all the
way down.
3. Lift the unit using the side handle while another person removes this side’s
bottom foam and the center bottom foams
B
. Gently release the device to rest
on the ground.
4. Carefully pull the unit using the handle. Retire the bottom foam from the other
side
C
.
5.
Keep pulling the unit to its final position.
Quick Start Guide
Smart Cabinet
Full system setup
1. Unload any material loaded on the printer and turn it off.
2. Unplug the power cable and keep it to use it later.
3. Carefully place the BCN3D printer on top of the Smart Cabinet seated in the
metal corners.
Quick Start Guide in your
own language
Unboxing
Watch our video to see
how to correctly unbox
the Smart Cabinet.
Unboxing video
Full system setup
Watch our video to see
how to correctly do the
full system setup.
Set up video
The device is heavy and it is recommended that this step is performed by two people.
For more detailed
information about the
processes, read the User
Manual.
User Guide
The initial indications of the unboxing are indicated on the box itself, with the
following drawings:
The printer is heavy and therefore this step needs to be performed by two people. Make
sure that the Smart Cabinet where the printer is being installed, is close enough.
Retain packaging and pallet for warranty service.
Remove the
red pallet
straps
Remove the
pallet
Cut the white
box straps
Lift the upper
box
Open the
plastic bag
and read the
documentation
A
B
C
4.
On the back, take out the teflon tubes from the FRS quick connector
D.1
.
5.
Take the correct set of extension teflon tubes from the upper foam.
There are two sets, one suitable for Epsilon W50 and another for Epsilon W27/Sigma D25. Use
the ones that adapt to your printer.
i
x2
