3
Assembly Guide
Assembly guide for London Shelving System
Basic assembly
Starter units consist of a 60/30 shelving system á two uprights and two crossbars (with
84”/212 cm og 90”/229,5 cm high sections may require a third crossbar in each
section, depending on the intended load; while heights above that should have three
crossbars in any case). For more info see “Assembly Guide for 60/30 Steel Shelving
System”.
For heights 84”/212 cm and 90”/229,5 cm, shelf depth and intended use of the
shelving may require either floor-mounting brackets (for double-faced shelving) or
wall-mounting brackets (for single-faced shelving). For double-faced shelving higher
than 90”/229,5 cm (with 10”/25 cm deep shelves or less) it is strongly recommended
that “L” shaped floor mounting brackets be used; four for each interior upright and two
for each upright at the ends of the ranges. The “L” bracket should be secured into the
foot of the upright, and also into the floor using fasteners appropriate to the floor
type, taking the shelving into consideration.
Install shelves and components into the section as required.
In cases where floor-mounting is not used, the shelving system may require further
minor leveling after it is loaded. This can be achieved by using an open-end wrench on
the leveler nut.
Pre-Assembly
Remove all the end caps in the upright tops.
Be sure that the depth of the shelf corresponds to the depth of the upright.