5
EN
G
LIS
H
Example position voltage selector:
220V for Europe 110V for USA
fuse T3AL/250V
fuse T6AL/110V
④ AC MAIN INPUT
Once all connections to the amplifier, plug the power cable
into an outlet and turn the unit on. Your CD Player is now
ready for use.
SWITCH ANTI-HUM (GROUND ON / OFF)
Your amplifier has a mains socket
outlet with a ground connection. The
use of this type of connection is
recommended for electrical safety
reasons (including wetlands). However
sometimes this connection "mass" is the origin of "hum"
audible from the speakers in a hi-fi system to solve this
problem, the cancellation of the ground connection is
sometimes sufficient. To do this you have, under the
amplifier, a switch to choose to connect or not the mass of
the device to the mains.
① ON / OFF BUTTON
.
This switch allows shutdown or operation of the CD Player.
② DRAWER DOOR CD
.
This drawer is designed to receive the CD. Caution should
never manipulate the drawer by hand but still pass through
the control buttons on the front panel or remote control to
proceed to the opening or closing. When the DISC TRAY
open insert a facing down on the CD tray.
If the message "No Disc" appears on the VFD drive, the disc
is probably on the wrong side.
③ LCD DISPLAY
.
The LCD display shows the various functions for the CD
Player as all major modes and settings.
④ CONTROL BUTTONS
.
This command allows you to adjust the output levels on the
left and right channels. At the center position, the output
level of each channel is equal.
PLAY (PLAY) / PAUSE:
Press this button to start playback or
resume playback after Pause. If the disc tray is open, press
this button to automatically close the tray and start
playback if the disc is loaded.
During playback, press this button to pause playback while
maintaining the playhead to where it is on the disc surface.
To resume playback at the exact time of the pause, press
PLAY / PAUSE.
SKIP / SCAN:
Press ">>" or "<<" to move to the next or
previous track. Forward or backward in an accelerated
manner, hold the ">>" or "<<" button continuously. The
optical pickup is then read before the recording or
backward at high speed.
STOP:
Pressing once on the *STOP+ button stops playback
and resets the playhead at the beginning of the disc. The
display returns to the display of the number of tracks and
total playing time on the disc. If you programmed the CD
player to play a selection of tracks, the program will be
stored in the player's memory.
In the programming mode, you can remove a program by
pressing twice on the *STOP+ key.
.
OPEN / CLOSE:
Press this button to open and close the disc
tray.
Connections
Connections and uses
Front panel
Under the CD Player
