CODATA Installation Manual V2 - OCT 12.doc
- 3 -
1. PRE-INSTALLATION CHECKS AND SAFETY PROCEDURES
UNPACKING
Check packaging -
Upon taking delivery of the unit, inspect the packaging for signs of
damage. If damage has occurred, advise the carriers and/or the suppliers immediately.
Check contents -
Upon taking delivery of the unit, unpack the unit carefully and check
that all the items are present and correct. If any items are missing or damaged, contact
your equipment dealer.
Retain packaging -
The shipping carton is the safest container in which to transport the
unit. Retain undamaged packaging for possible future use.
IMPORTANT SAFETY PRECAUTIONS
Read instructions -
All relevant safety, installation and operating instructions should be
read before attempting to install, connect or operate the unit.
Retain Instructions -
All safety, installation and operating instructions should be retained
for future reference.
Heed warnings -
All warnings on the unit and in any relevant safety, installation or
operating instructions should be adhered to.
Cleaning -
Unplug the unit from the power outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Attachments -
Do not use attachments not recommended by the product manufacturer as
they may cause hazards.
Water and moisture -
Do not expose the internal electronics of this unit to water or
dampness; for example, in an unprotected outdoor installation, or in any area classified
as a wet location.
Accessories -
Do not attach this unit to an unstable stand, bracket or mount. The unit
may fall, causing serious injury to a person and serious damage to the unit.
Power sources -
This unit should be operated only from the type of power source
indicated on the manufacturer’s label. If you are not sure of the type of power supply you
intend to use, consult your equipment dealer or local power company. For units intended
to operate from battery power or other sources, refer to operating instructions.
Power connector -
This unit is equipped with a single 2 pole power connector, mounted at
the rear of the CoData for low voltage power input. Do not attempt to alter this connector
in any way.
