BBT BBT-65PM, Руководство пользователя

Страница: 10 / 16

10 WWW.BBTA.COM.AU BBT-65PM
Regulation of the Drive Cable (b)
• If the drive system does not engage and disengage correctly, check the handle
for correct assembly. Make sure that all parts are in good condition and that all
the fasteners are tight.
• The drive system can slip if the drive cable (b), is too loose.
• If the drive system slips, you need to shorten the cable: turn the cable nut and
test the drive system.
• If the drive system still slips, repeat the adjustment and test until the drive
system does not slip.
• Before you begin to mow, make sure the drive system will correctly disengage
and that the mower will stop. If the drive system will not disengage, take the
lawn mower to an authorized service centre before you operate it.
• ATTENTION: Make sure that all cables are tense enough.
Engine Starting
Once the machine has been set up properly, start the engine as follows:
• Put the throttle control (4) in the START position or
• Take the engine control bar (3) and maintain it against the superior
handle, pull on the recoil starter handle (11) until you can feel
resistance and then pull harshly.
• Put the lever on RUN position
OPERATIONS
Engine delivered without oil: Add oil before starting the engine.
CAUTION
Check frequently and polish the gears in the wheels (14) and put grease on them. Do the same on the bar
bearing if any.
CAUTION
Blade is in action as soon as the engine starts. While the machine is working, maintain the throttle control
(4) in working position. The engine will stop as soon as you release the engine control bar (3).
WARNING
Before you adjust the drive cable (b), release the control bar and wait till the engine stops.
WARNING