bbraun 8717070, Руководство по обслуживанию

Страница: 62 / 106

3 Disassembly / Assembly
3 - 30 Infusomat® compact
plus
P 1.0 EN
For internal use, only
3.15 PUMP Designation Ord. No.
Pump ICP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34522206
(including stepper motor and encoder PCB)
Stepper motor CP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .34522107
Encoder PCB ICP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34522205
Disassembly
✓
Pump has been dismounted from the housing front.
1. Unscrew the two screws ( Fig. 3 - 42 / Item 1 ) using a 10IP
TORX plus screwdriver.
2. Remove the stepper motor ( Fig. 3 - 42 / Item 2 ).
3. Unscrew one screw ( Fig. 3 - 43 / Item 1 ).
4. Remove the encoder board ( Fig. 3 - 43 / Item 2 ) using a 10IP
TORX plus screwdriver.
Assembly
1. Tighten the screw of the encoder board with a torque of 0.8 Nm
± 0.08 Nm (first and second screwing).
2. Tighten the screws of the stepper motor with a torque of
0.7 Nm ± 0.07 Nm (first and second screwing).
Fig. 3 - 42
1 Screw DELTA PT 30x8 WN 5451
2 Stepper motor
1
2
Fig. 3 - 43
1 Screw DELTA PT 30x8 WN 5451
2 Encoder board
1
2
NOTICE
After exchanging the pump perform the "pump run-in" proce-
dure (
see "Checks after Repair" ➡ p. 3 - 32 ).