Lighting Burner With A Match:
1. Place a match in the end of the match holder that is pre-installed
on the side of Grill Housing. Once lit, immediately place the
flame through the hole as shown near the burner ports.
2. Press in knob and rotate counterclockwise to High setting and
burner should light immediately. If more than one burner is desired,
turn other knobs to “on” positions after first burner is lit.
3. Adjust burners to desired cooking settings.
Observe Flame Height When Lit: Flame should be a blue / yellow
color between 1- 2 in. high.
OPERATION INSTRUCTIONS
18
CAUTION:
All cleaning and maintenance should be done when grill is cool and with the gas supply turned off at
the propane cylinder.
DO NOT clean any grill part in a self-cleaning oven. The extreme heat will damage the finish.
Cleaning
Burning-off the grill after every use (approx. 15 minutes) will keep excessive food residue from
building up. To “Burn Off” or heat clean your grill, turn the 3 main burners to HIGH and run for 15
minutes with the lid closed. Then use a wire brush to clean the grids.
Recommended cleaning materials -
Mild dishwashing liquid detergent, hot water, nylon cleaning pad, wire brush.
DO NOT use cleaners that contain acid, mineral spirits or xylene.
Outside surfaces -
Use a mild dishwashing detergent and hot water solution to clean, and then rinse with water.
If the inside surface of the grill lid has the appearance of peeling paint, baked on grease buildup has
turned to carbon and is flaking off. Clean thoroughly with strong solution of detergent and hot water.
Rinse with water and allow to completely dry.
Interior of grill bottom - Remove residue using brush, scraper and/or cleaning pad, and then wash
with dishwashing detergent and hot water solution. Rinse with water and let thoroughly dry.
CARE AND MAINTANCE
Blue
Light Blue
Blue
Light Blue
Yellow
Yellow
Good
Bad
