9. The stock gear lever is not equipped with a shift linkage / rod. The Bazzaz shift switch installation requires the use
of after market rear sets for this application. First install the Bazzaz shift switch followed by the replacement shift rod
supplied with the kit. Adjust the combined length of these components to allow for complete actuation of the shift
shaft and also maintain a comfortable riding position. Once the desired length is established tighten the 10mm nuts to
secure the switch and rod in place. Route the wiring lead of the shift switch sensor into the engine compartment and
connect it with the mating connector on the Bazzaz harness. Secure any excess wiring length away from any hot or
moving components on the bike, as contact with these components may cause damage or failure to the sensor.
(Photo 8)
Notes: (1) The female end of Bazzaz shift switches are cross tapped to allow them to be mounted to either the rear set
or shift shaft heim joint regardless of the thread design. (2) If the replacement rod supplied with your kit contains fe-
male style ends, it is design to allow the user to shorten its length to suit various aftermarket reset configurations. The
female style rods contain grooves in 10mm increments on both ends identifying areas where the rod can be modified
and adequate threads will remain for proper installation.
10. Now that the Bazzaz hardware installation is complete please verify proper installation and system functionality. If
any problem is found, please carefully follow through the installation steps again. If problem still persists, please call
Bazzaz tech support department at (909) 597-8300. After it is determined that everything is correct take a moment to
secure the Bazzaz harness along its routing path with cable ties. Secure wiring away from any hot or moving compo-
nents on the bike, as contact with these components may cause system damage or failure. Reinstall the components
removed in step 1.
Photo 8
