SCION
tC
2005 -
VSE SUBWOOFER (BAZOOKA
®
)
Procedure
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this
accessory should follow approved guidelines to ensure a quality installation.
These guidelines can be found in the "Accessory Installation Practices" document.
This document covers such items as:-
•
Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).
•
Safety (eye protection, rechecking torque procedure, etc.).
•
Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
•
Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
Please see your Toyota dealer for a copy of this document.
1. Pre-installation Precautions
(a) Use Seat & Floor Protectors and Fender
Covers/Blankets to avoid damage to surfaces.
2. Battery Disconnect
(a) NOTE: Be sure to open the rear hatch,
PRIOR
to disconnecting the battery.
(b) For vehicles equipped with automatic
transmission, place the shifter in the N
(neutral) position and set the parking brake
prior to disconnecting the battery.
(c) Remove the NEGATIVE (-) battery terminal
using a 10mm socket before any disassembly
starts. (Fig. 2-1)
Fig. 2-1
3. Disassemble Rear Cabin Interior Components
NOTE: ALL INTERIOR COMPONENTS
THAT ARE REMOVED FROM THE
VEHICLE MUST BE PLACED ON A CLEAN
& PROTECTED SURFACE (i.e. Blanket)
(a) Starting at the rear of the vehicle, remove and
secure the rear Tonneau Cover.
(b) Proceed to unlock the two (2) knob locks and
remove and secure the rear Cargo Floor panel
& floor mat (if equipped).
(c) Proceed to remove and secure the rear cargo
entry scuff plate by pulling upwards.(Fig. 3-1)
Fig. 3-1
Page 2 of 17 pages
Issue: A 04/15/04
