T R U C K I N S T A L L A T I O N
tube size is exagerated for emphasis
S E D A N I N S T A L L A T I O N
tube size is exagerated for emphasis
H A T C H B A C K I N S T A L L A T I O N
tube size is exagerated for emphasis
4
INSTALLATION
Figure 1
Figure 2
Figure 3
The 16 gauge black wire on the 14-pin Molex Mini-fit Jr. connector is the
negative ground wire. It must be connected directly to the vehicle chassis
near the amplifier. We do not recommend extending the ground wire in
any installation, as this can cause unwanted ground loops.
The ground point in the car should be a piece of chassis metal that is part
of or welded to the main body of the vehicle. Painted surfaces should be
scraped or sanded clean to expose the bare metal before the ground lug
is bolted down. (Cover the bare metal area with paint or grease after you
finish mounting the ground wire to prevent rust.)
GROUND WIRE
REMOTE TURN ON OPTIONS
11
The ORANGE wire on the Amplified Bazookas' 14-pin Molex Mini-fit Jr.
connector is the Remote Turn On Wire. You have several options in
connecting the Remote Turn On Wire. These options are listed in the order
of preference recommended by SAS. Select the option best suited for your
application.
Option One:
For the most versatility the Remote Turn On Wire should be connected to
one terminal of the SAS On/Off Switch, with the other terminal connecting
to the source unit's "Accessory", "Auto-Antenna" or "Remote" lead -- any
of which will supply 12 Volts positive when the source is turned on. The
SAS On/Off Switch allows you to demonstrate to others the difference the
Amplified Bazooka makes in your system, or you can turn the Amplified
Bazooka off whenever you desire. When you are using this configuration,
the Quick Disconnect YELLOW On/Off Jumper Loop MUST be disconnected
from the wiring harness.
Mounting The Switch:
The SAS On/Off Switch has a variety of mounting options. Supplied
with the switch is a mounting plate for under dash applications.
