BayTech RPC-2, Руководство пользователя

Страница: 44 / 88

RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
37
LOCAL ACCESS Load serial port communications software.
USING EIA-232 Configure host terminal’s serial
SERIAL CONNECTION communications parameters to match the
RPC. RPC factory serial communications
parameters are 9600 bps, 8 data bits, 1 stop
bit, and no parity.
The RPC Series has an RJ-45 port
for connecting to a local EIA-232 device,
such as a computer terminal or external
modem. Most serial computers do not have
RJ-45 connections; therefore, an adapter is
provided with this unit to convert from a
DE-9 connector to a RJ-45 connector
(BayTech Part No. 9FRJ45PC-1). If you are
connecting to a modem, use a modem
adapter (BayTech Part No. 25MRJ45MD-8).
Using the 9FRJ45PC-1 adapter (or other
applicable adapter) and the RJ08X007
crossed cable, connect the serial port of your
computer to the RJ-45 port labeled “EIA-
232” on the back of your RPC unit.
REMOTE ACCESS The RPC Series has an Ethernet
USING NETWORK port for connecting to a network.
PORT CONNECTION
I
n order for a network connection to be
established, at a minimum, you must
configure the IP Address, Subnet Mask, and
if applicable, Gateway. Network
configurations must be set initially through
the serial port but may be modified using
either the serial or Ethernet port..
Once you have configured the IP Address,
Subnet Mask, and Gateway through the
serial port, a network connection can be