Installation Instructions
2
|
P a g e
V 1 . 1 P u b l i s h e d o n . 0 8 . 2 0 1 8
Installation Directions
Remove all packaging material from the product and be careful not to throw away accessories that may be hidden within
the packaging material. If assembly is required, place the luminaire on a smooth non-scratch surface.
1.
Open the luminaire by unclipping the clips on the side. Fig.1
2.
Carefully lift the LED module plate to find the accessories bag. Fig.1
3.
Select the installation type suitable for your location:
Flush mount installation:
Suspension installation:
Mark the screw position on the ceiling, refer to dimension
A in the specifications table.
Install the mounting brackets onto the ceiling using
appropriate size mounting screws. Ensure the screws are
suitable for the mounting surface and surrounding
environment.
Install the steel chain hanging system (not included) on
the ceiling, refer to dimension A in specifications table.
Secure the hanging bracket to steel chain and the
mounting brackets.
Push and press the luminaire onto the mounting brackets. Fig. 2
4.
Install the cable gland onto the luminaire. Insert the mains supply wire through the cable gland. Fig. 3
5.
Attach the LED module plate to the luminaire using the hanging strips. Fig. 4
6.
Select the lighting mode required and follow the wiring method below:
Normal lighting mode
:
Install an On/Off switch (not included) to control the
normal light.
Emergency lighting mode
:
7.
Connect the mains supply wire to the terminal block. Ensure wires are secure and no bare wires are exposed.
Tighten the cable gland (Fig.4)
8.
Insert the male plug of battery wire into the female socket of the emergency controller. Fig. 5
9.
Indicator light is on during battery charging period. Press the test button to switch to emergency lighting mode.
Indicator light will be off in emergency mode. Fig. 5
10.
Install the LED module plate into the luminaire and secure it by rotating the plastic wing nut. Fig.6
11.
Install the diffuser onto the luminaire and secure by locking the clips on the side. Fig.7
12.
After the installation, switch on the fitting to test and enjoy your new lighting product.
