Installation Instructions
1 |
P a g e
v 1 . 1 ( 0 2 / 2 0 1 9 )
BRISTOL FLUSH MOUNT WITH EMERGENCY LIGHTING
SKU# 189199
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Bayside product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this luminaire. Please keep instructions for future reference.
Warranty
This luminaire is covered by a 2 year warranty. The warranty is from date of purchase, not the date of installation.
If the luminaire is not assembled and installed by a licensed electrician the warranty will be void.
Please retain proof of purchase and evidence of installation by a licensed electrician for any warranty enquiries.
Warranty will be void if there is any damage due to improper usage or modification to the luminaire.
The use of non-compatible dimmers may damage your luminaire and will void your warranty.
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
Installation Requirements
Must be assembled and installed by a licensed electrician.
All wiring and installation of the luminaire must adhere to the latest local and national wiring rules.
eg. AS/NZS 3000 Electrical Installations.
This is a Class II luminaire and must be maintained during wiring and installation
This luminaire is rated IP54, this must be maintained during wiring and installation.
Select a suitable location for installation:
- This luminaire is protected against water penetration to IP54 standards, which is splashing in every direction.
- The mounting point must support 2 times the weight of the luminaire.
This luminaire is dimmable and has been tested at the date of publication with the dimmers listed in the specification
section. The use of a LED dimmer such as the Lucci LEDlux SKU# 290998 or SKU# 290997 dimmer is highly
recommended.
NOTE:
For the best dimming range, use with the Lucci LEDlux SKU# 290998 dimmer and adjust the variable
resistor at minimum and maximum dimming positions on the dimmer during the installation.
NOTE:
Dimming may cause buzzing sounds or a slight flicker. There may be slight delays with the LED light start
up or slight uneven light performance when more than one LED luminaire is linked together, switched ON or
dimmed. This is not a product fault and as such is not covered under warranty.
NOTE:
Some dimmers have a minimum load of 20W. Ensure the dimmer position is on the maximum setting before
turning on the LED light and adjust the dimmer down to your desired light level.
CAUTION:
risk of electric shock
. The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire will require replacement.
Take care not to pull any electrical wires during unpacking as this may damage the connection.
Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
Check whether the luminaire has been damaged during transport. Do not operate/install any luminaire which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
Ensure power to the circuit you are working on has been switched OFF, before commencing any electrical work.
