13
July 21, 2012
NOTE: When 240 volt power is supplied from shore power from a 50 amp
connection or 2@30 amps feeds as described above, or from the generator, the
remove trace inverter panel on the left of the AC Panel sidewall will indicate good
power source when the two green indicator light are on , one solid and one
blinking. Also the inverter orange light to the left will come on for a few seconds
and then automatically it will switch to the right top under “ bulk” this indicates
that the inverter charging system is active. When the inverter sees full charge the
light will drop to the lower “float”position and turn green. The two green light
should always be on when a power source is supplied by one 50 amp cord
including when using adapters
If a red error light appears or if only the orange inverter light is still on you are not
getting an AC power source nor is the charging system active, and batteries will
run down. Check for the proper position of the panel breakers, the shore power
connection and or pedestal breaker on the dock and be sure the digital readout
setting is on “ Set Inverter, and the source indicator ( small underline indication) is
set to float. This needs attention and resolution before moving on to other
activities. Hopefully this will not occur but if so refer to the race(Zantrax) manual
overhead in the pilot house or the abbreviated copy on the actual inverter in the
engine room. Occasionally the remote inverter panel is illegible and you will need
to go to the main inverter control panel (identical appearance) on the face of the
inverter in the engine room o make settings if needed.
NOTE: when operating on inverter power only you should see only the orange
inverter light on. If there are no lights on, there is no AC power available on the
boat.
IF ADJUSTING THE INVERTER SETTINGS IS REQUIRED, CALL AYC OR
THE OWNER FOR TROUBLE SHOOTING HELP!
