Bayliner 2858 Classic Cruiser, Дополнение к руководству пользователя

Страница: 36 / 56

Chapter 2: Features & Systems 2858 Classic Cruiser • Owner’s Manual Supplement
30
Sink & Shower Drain Systems
Gray water (water from sinks and showers)
above the waterline is gravity drained
overboard, while gray water below the
waterline is pumped overboard using a
sump pump.
The sump box (A), containing the sump pump,
float switch, and filter is located under the
salon floor (see the illustration on the right).
Sump Box Cleaning
The sump box, filter, and pump should be
periodically cleaned of debris as follows:
1. Remove cover screws (B) and cover (C).
2. Remove any debris from box and filter.
3. Clean sump pump as outlined in Bilge
Pump section of this Supplement.
Sump System Winterization
Drain the sump pump system in the winter
months when not in use.
1. Disconnect and drain all lines to unit.
2. Remove screws from mounting feet (D)
and drain system.
3. Reinstall screws in mounting feet and
reconnect system.
Seawater Systems
Seacocks
•
A seacock is a valve that is used to manage the intake of
seawater through the hull and below the water line.
•
Seacocks are controlled by a 90º lever and are used on the
seawater intake systems for the air conditioning system
(if equipped) and marine head (toilet) system.
•
Before using any of these systems, make sure that the system’s
seacock is Open and remains in the Open position until the
system is shut Off.
A
B
D
C
SUMP PUMP ACCESS
INTAKE STRAINER
HULL
SEACOCK GASKET
SEACOCK (TYPICAL)
SEACOCK
LEVER
SECTION
SEAWATER INTAKE VALVE (SEACOCK)
COMPONENTS (TYPICAL)
90 DEGREE
CAUTI O N!
SYSTEM DAMAGE HAZARD!
•
Before using a seawater intake system, make sure that the system’s seacock is in the Open
position before the system is started and keep the seacock Open until the system is shut Off.
•
Close seacocks whenever the systems will not be used for long periods of time
!