2
ENGINEERING CONTROLS
When handlers use closed systems or enclosed cabs in a manner that meets the requirements listed in the Worker Protection Standard
(WPS) for agricultural pesticides [40 CFR 170.240 (d) (4-6)], the handler PPE requirements may be reduced or modified as specified in
the WPS.
User Safety Recommendations
Users should:
•
Wash hands before eating, drinking, chewing gum, using tobacco or using the toilet.
•
Remove clothing immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing.
•
Remove PPE immediately after handling this product. Wash the outside of gloves before removing. As soon as possible, wash
thoroughly and change into clean clothing.
ENVIRONMENTAL HAZARDS
This chemical can contaminate surface water through ground spray applications. Under some conditions, it may also have a high
potential for runoff into surface water after application. These include poorly draining or wet soils with readily visible slopes toward
adjacent surface waters, frequently flooded areas, areas overlaying extremely shallow ground water, areas with in-field canals or
ditches that drain to surface water, areas not separated from adjacent surface waters with vegetated filter strips, and areas overlaying
tile drainage systems that drain to surface water.
This pesticide is toxic to invertebrates. Do not apply directly to water or to areas where surface water is present or to intertidal areas
below the mean high-water mark. Drift and runoff may be hazardous to aquatic organisms in neighboring areas. Do not contaminate
water when disposing of equipment washwater or rinsate.
DIRECTIONS FOR USE
It is a violation of federal law to use this product in a manner inconsistent with its labeling.
Read entire label before using this product.
Do not apply this product in a way that will contact workers or other persons, either directly or indirectly or through drift. Only protected
handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for
pesticide regulation.
AGRICULTURAL USE REQUIREMENTS
Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR part 170. This Standard
contains requirements for the protection of agricultural workers on farms, forests, nurseries, and greenhouses, and handlers of
agricultural pesticides. It contains requirements for training, decontamination, notification, and emergency assistance. It also contains
specific instructions and exceptions pertaining to the statements on this label about personal protective equipment (PPE) and restricted-
entry interval. The requirements in this box only apply to uses of this product that are covered by the Worker Protection Standard.
Do not enter or allow worker entry into treated areas during the restricted entry interval of 12 hours for ornamental uses.
PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with
anything that has been treated, such as plants, soil, or water is: coveralls, chemical-resistant gloves, and shoes plus socks.
NON-AGRICULTURAL USE REQUIREMENTS
The requirements in this box apply to ornamental and turf uses (golf courses, landscape and institutional areas) of this product that are
NOT within the scope of the Worker Protection Standard (WPS) for agricultural pesticides (40 CFR Part 170). The WPS applies when
this product is used to produce agricultural plants on farms, forests, nurseries or greenhouses.
Do not enter or allow others to enter the treated area until sprays have dried.
