Bayby BBM 7005, Руководство пользователя

Страница: 12 / 16

Digital Audio Baby Monitor
EN
12
Low battery voltage indicator
■
If the batteries have the correct voltage, the LED indicators B5 or C6 are lit green on both the units after
they are turned on.
■
When the batteries have a sufficiently low voltage, the LED indicators will be lit orange and later red. When
this happens, replace or recharge the batteries as soon as possible, or connect the units via USB power
cables to a power source.
Installation location of the units
Parent unit
■
Put the parent unit A 1 in the room where you will be located. When the parent unit is to be powered from
the grid, locate it within reach of a power socket.
Baby unit
■ Locate the baby unit
A2
within reach of a power socket on an even, dry and stable surface in the room where
you want to monitor your child. We recommend an elevated location (e.g. chest of drawers or a shelf) at
a sufficient distance away from equipment and devices that could cause signal interference.
■ Locate the baby unit at least 1.5 m away from your child to minimise the effects of electro-smog.
Attention:
Never locate the baby unit or the USB power cable in the baby’s bed or within your child’s reach.
Incorrect distance between the units
■
If the parent unit is located too far from the baby unit, it will beep and the LED volume level indicator B4 will
start flashing. If this happens, reduce the distance between the parent unit and the baby unit.
■ If the parent unit is located too close to the baby unit, you may hear an unpleasant audio noise or a high-
tone sound. If this happens, move the parent unit farther away from the baby unit, or reduce the volume
level on the parent unit.
General information about using the baby monitor
■
Before using the baby monitor for monitoring your child, always check that both the baby and parent unit
and are in working order, that there is a connection between the units and that audio is being transmitted.
In the event that there is no connection between the baby and parent unit and (the baby unit is turned off or
out of signal range), the LED indicator
B4 will start flashing and sound an acoustic alarm signal (beeping).
■
The sound detected by the baby unit is transmitted to the parent unit. LED indicator B4 will inform you about
audio transmission. This will be particularly useful when the parent unit A1 is set to a low volume.
■ To increase the signal range, place the baby unit
A2
in an elevated location as close as possible to the door
or window.
■
Other radio waves may interfere with the signal transmission. For this reason, do not place the baby monitor
in the vicinity of appliances such as e.g. a microwave oven or WLAN devices, etc.