40
Remove the top cable clamp using a
# 2 square bit screwdriver.
Remove the bottom cable clamp using a # 2
square bit screwdriver.
Remove the cotter pin (part # A5PICZ001) and
slide the wheel link off of the pivot arm.
Unplug the 2 pin molex connect for solenoid
power.
Remove the 2 top nuts, lock washers, and washers of wheel
cradle frame using a 1/2” wrench, and remove the bolts.
HOW TO REPLACE SOLENOID
The wheel must be swung outward to access and replace the solenoid assembly.
Tools Needed:
Phillips Screwdriver
# 2 Square bit
7/16” wrench
1/2” wrench
Instructions:
The arrow sensor must be removed so it does not
damage
the wheel, refer to “How to Remove Arrow Sensor”
Remove the 2 top nuts, lock washers, and washers of wood side
braces using a 7/16” wrench, and remove the bolts.
Swing the 2 wood side braces down.
The wheel will tilt down and rest on these braces.
