10.0 Changing Components
40
10.10
Burner (Fig. 113)
1. Remove the burner assembly by pulling it
forward.
2. Fit new burner and re-assemble all components
in reverse order of dismantling.
10.11
Burner Injector (Fig. 114)
1. Release and remove the burner injector which
is screwed into the burner feed manifold.
2. Fit the new burner injector ensuring that the
copper washer is in position. Tighten the injector
fully.
3. Re-assemble all components in reverse order.
10.12
Pilot Burner Injector (Fig. 115)
1. Remove the right hand side insulation carrier
bracket by releasing the screw. Remove the side
insulation panel.
2. Release the screw securing the pilot hood and
remove. Carefully remove the pilot injector. Fit the
new pilot injector ensuring the new sealing washer
is in position. Tighten the injector fully.
3. Re-assemble all components in reverse order.
10.13
Gas Manifold (Fig. 116)
1. Remove the right hand side insulation carrier
bracket by releasing the screw. Remove the side
insulation panel (Fig. 113).
2. Remove the two screws securing the manifold
from the inside of the combustion box and slide
the manifold forward from under the two rear
locating studs.
3. Remove valve and ancillary components from
manifolds as necessary.
4. Replace all ancillary components onto manifold
and replace manifold by sliding rear edge
backwards under the two rear locating studs and
securing from inside the combustion box using the
two screws previously removed. Ensure that the
sealing gasket is properly positioned and
undamaged.
60, 70 & 80 PF
Models Only
Fig. 113
Fig. 114
Fig. 115
Fig. 116
Pilot Hood
Pilot Injector
Sealing Washer
