Flue collar, down draught diverter, diverter box, flue spigot and flue restrictor
plate.
These should be assembled to the stove as in figure 2. The flue spigot is screwed to
the cast collar and clamps the flue restrictor plate in place (See figure 2).
5.
The down draught diverter is secured in place using the front bolt and nut that
secure the cast collar to the outside of the cast body. Unscrew and remove the nut
and washer from inside the top of the casting body. Position the down draught
diverter as in figure 3. It MUST be sealed against the top of the stove casting. It is
important that it sits on top and between the raised cast areas on the rear of the stove
body (See figure 3). Secure in
place using the nut and washer
removed previously.
Page 7
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 3.
Figure 2.
