Baumuller b maXX BMC-M-SAF-02, Руководство по эксплуатации

Страница: 73 / 120

Commissioning
Operation Manual b maXX safe PLC BMC-M-SAF-02
Document no.: 5.07020.04
73
of 118
11
11.9.2 Starting behavior with inserted memory card
Figure 17: Flow diagram
m
Read and observe chapter
Z
Safety
–
on page 17.
m
The “Assembly and installation” section will have to have been conducted correctly.
No
Yes
Is the
project check sum
identical?
Waiting for an entry
yellow LED H3 blinks
The control runs up
to the “RUN” status.
Press the button short
yellow LED H3 blinks
Press the button long (> 3 s)
green LED H4 blinks
Abort of
the entry, if
pause > 10 seconds
Abort of
the entry, if
pause > 10 seconds
Code entry
copy code (2-digit)
green LED H4 blinks
Yes
First trying?
No
Correct code
entered?
Correct code
entered?
No
No Yes Yes
Safety PLC runs up
to error state without
a project
standard PLC runs up
to STOP state
Copying the project
from the CF card
to the controller
yellow LED H3 lights up
Copying the project
from the controller
to the CF card
green LED H4 lights up
Controller in
STOP state
yellow LED H3 off
Notice:
If an error occurs
during copying the
project, the red
LED H4 will go on
Controller in
STOP state
green LED H4 off
Code entry
release code (3-digit)
yellow LED H3 blinks
Is CF card available?
No
Yes
Is a s
F card?
afety project
present on the C
No
Yes