Baumuller b maXX 1000, Руководство по параметрам

Страница: 111 / 210

Parameter
Parameter manual b maXX
®
1000
Document no. 5.07004.03
111
of 208
4
P1168
This parameter sets the function of the AO2 output 0 to +10 V
DC
(ACM is signal ground),
see also
Z
P1169
–
from page 111.
P1169
This parameter sets the voltage range of the analog output signal AO2.
When
Z
P1168
–
is set to 0, the analog output voltage is directly proportional to the output
frequency of the b maXX
®
1000. With
Z
P1169
–
set to 100 %, the maximum output fre-
quency
Z
P0033
–
of the b maXX
®
1000 corresponds to +10 V
DC
on the AO2 output.
Similarly, if
Z
P1168
–
is set to 1, the analog output voltage is directly proportional to the
output current of the b maXX
®
1000. With
Z
P1169
–
set to 100%, then 2.5 times the rated
current corresponds to +10 V
DC
on the AO2 output.
For Example: When using the meter with full scale of 5 volts, adjust
Z
P1169
–
to 50 %. If
Z
P1168
–
is set to 0, then 5 V
DC
will correspond to maximum output frequency.
P1168 Analoges Ausgangssignal AO2 0 to 1
EE Analog output signal AO2 0
STOP BM_u_AnalogOutputSignal2 1:1
Value Meaning
0 Analog frequency meter (0 to maximum output frequency)
1 Analog current meter (0 to 250 % of rated current)
P1169 Analoges Ausgangssignal Verstärkung AO2 0 to 200 %
EE Analog output gain AO2 100 %
STOP BM_u_AnalogOutputGain AO2 1:1
NOTE
Any type of voltmeter can be used. If the meter reads full scale at a voltage less than 10 V,
Z
P1169
–
should be set using the following formula:
Z
P1169
–
= ((meter full scale voltage)/10) x 100%