PAGE 15
TP10432
RECALL
(N) - (Y) ENTER
RECALL
(N) - (Y) ENTER
STORAGE
(N) - (Y) ENTER
9.2 Setting up a special fold.
This machine has 3 memory locations that can be used
to store special fold settings. These will store the plate
settings, the stacker wheel location, and the speed setting for
a fold.
9.2.1 To save a nonstandard fold in a memory
location 3
Set up the fold as you normally would. Once the speed
and folds are set the way you want, press a
“MEMORY
SET”
button. Recall will appear in the display. Press the
(-)
button to get to the
STORAGE
screen.
9.2.2 Recall a fold saved in memory location.
Press the
“MEMORY SET”
button that corresponds
to the memory location you wish to recall.
RECALL
will
appear. Press the
ENTER
button.
9.3 Starting Production:
After the
sheet length
and the
fold type
has been
selected, production
is started by:
Starting the main drive (press
“DRIVE”
),
·
The 8 Page Drive must be started first then the Parallel
unit. The Parallel Unit will not start if the 8 Page Unit is
not running.
·
Notes:
If the wrong
“FOLD TYPE”
button is pressed, you
can either press the
“RESET”
button instead of the
9.3 Continued
“ENTER”
button or press the correct
“FOLD TYPE”
button,
then the
“ENTER”
button.
After every new set up the machine speed will always be
reset to 60%.
The fold type status LED, when lit constantly, indicates
that the fold plates are set for this type of fold.
Any time the folder is running and a change is made that
causes the fold plate stops to move; the main drive will stop.
