Baumer HUBNER BERLIN PROFI NET microGen HMG10P, Руководство по эксплуатации

Страница: 39 / 44

Baumer Hübner Technical data | 8
V1, T1 | HMG10 & HMG10P EtherNet/IP Operating Manual 39
8 Technical data
HMG10
Electrical Data
Voltage supply Ub 10-30 V DC
Short-circuit proof Yes
Operating current without load ≤ 200 mA
Initializing time ≤ 500 ms after switch-on
Sensing principle Magnetic
Fieldbus interface EtherNet/IP
Data rate (programming interface) 100 Mbit/s
User address HEX rotary switch in the bus terminal box or
with BOOTP/DHCP tool
Steps per turn 8192 / 13 Bit
Number of turns 65536 / 16 Bit
Incremental output Rectangle TTL/HTL, TTL/RS422
Interference immunity see data sheet and declaration of conformity
Interference emission see data sheet and declaration of conformity
Programming interface RS485 (≤ 600 m)
I
Programmable parameters Bus system (see reference at the end of the
chapter)
Additional output (ppr number)
I
Switch off / on speed
I
Diagnostic functions Position and parameter errors
LED status indicator DUO LED and Link/Activity LEDs in bus termi-
nal box
4 LEDs at rear of the device
Approvals see data sheet and declaration of conformity
Electrical data (Speed switch)
Switching accuracy ±2 % (or 1 digit)
Switching outputs 1 output
(Open-collector
II
or semiconductor relay
II
)
Output switching performance 30 V DC; ≤ 100 mA
Switching delay ≤ 20 ms
Mechanical
Dimensions (flange) ø 105 mm
Shaft type HMG10-B
ø 16...20 mm (blind hollow shaft)
ø 17 mm (cone shaft 1:10)
HMG10-T
ø 16...20 mm (through hollow shaft)
Flange Torque plate, in any position throughout 360°