Baumer HUBNER BERLIN PROFI NET microGen HMG10P, Руководство по эксплуатации

Страница: 38 / 44

7 | Disassembly Baumer Hübner
38 Operating Manual HMG10 & HMG10P EtherNet/IP | V1, T1
7.2 Detaching the encoder from through-hollow shaft
DANGER
Burns caused by heat
The device heats up at high torque. There is a risk of getting burned after use.
a) Avoid overheating the device.
b) Wear suitable gloves.
1 3 2
9 7 8 4
4
1
1
4
≥
ø
d
>113 mm
ø
d
5 6
Ill. 11: Detaching the encoder from the through-hollow shaft
1 Self-locking nut M6 (ISO 10511) 2 Threaded rod M6 (variable length ≤ 210
mm)
3 Grounding strap 4 Washer B6.4 (ISO 7090)
5 Through hollow shaft 6 Torx screw M3x12 mm (ISO 7045)
7 Torque arm 8 Cheese-head screw M6x8 mm for
grounding strap (ISO 1207)
9 Washer B6.4 for grounding strap (ISO
7090)
Tool
n
1,6×8 mm
n
10 mm
n
10 mm
Instruction:
a) Loosen the Torx screw at clamping ring. Do not unscrew the screw completely.
b) Loosen the self-locking nut on the torque arm
c) Loosen the cheese-head screw at grounding strap.
d) Slide the encoder off the shaft.