Baumer Hubner Berlin microGen PMG10 CANopen, Руководство по эксплуатации

Страница: 27 / 40

Baumer Hübner Electrical installation | 6
V1 | PMG10 & PMG10P CANopen Operating Manual 27
6.2.6 Output switching behavior Speed switch (optional)
INFO
Default switching speed is 6000 rpm for HMG10P and PMG10P. HMG10 and PMG10 without
programming interface come with the individually ordered permanent switching speed.
Event Speed switching output state
During initialization High-impedance (overspeed)
After initialization and speed being ≤ -ns (off) High-impedance (overspeed)
-ns (off) < speed ≤ -ns (on) Status unchanged
Device rotation within this speed range during
initialization results in status low-impedance
(no overspeed) after initialization
-ns (on) < speed ≤ +ns (on) Low impedance (No overspeed)
+ns (on) ≤ speed < +ns (off) Status unchanged
Device rotation within this speed range during
initialization results in status low-impedance
(no overspeed) after initialization
+ns (off) ≤ speed High-impedance (overspeed)
n = Speed
+ns (off) = Switch-off speed at shaft rotation in positive rotating direction*
-ns (off) = Switch-off speed at shaft rotation in negative rotating direction*
Switching hysteresis : 10...100 % (factory setting = 10 % min. 1 Digit)
+ns (on) = Switch-on speed at shaft rotation in positive rotating direction*
-ns (on) = Switch-on speed at shaft rotation in negative rotating direction*
Low resistance
Resistance between
SP+ and SP-
High resistance
-ns (on) 0 +ns (on)
-n +n
-ns (off) +ns (off)
6.2.7 Connecting the supply cable
NOTICE
Equipment damage due to dust or moisture
Inappropriate cable diameters may entail ingress of dust or moisture. In this case, the protection
class is no longer ensured causing device failure or malfunction.
a) Use only appropriately sized cables to make sure the specified protection class is being en-
sured.
INFO
Connection cables are not included in delivery.