Baumatic BT2385SS, Инструкция по эксплуатации

Страница: 26 / 36

Instructions for use, installation and connection
26
Troubleshooting guide
Any unskilled attempt to repair the appliance
is extremely dangerous as it might cause
electric shock and short circuit. To avoid
such injuries any repairs may be performed
only by qualified personnel, or after sales
service.
However, there are some minor faults which
may be easily removed by the user, in
accordance with the instructions that follow.
Important!
If the malfunction of the appliance was
caused by the improper use, the service visit
during the warranty period is not free of
charge.
Following are some simple advice how to
repair minor faults:
Program clock indicates faulty
values or switches on and off
intermitently…
Switch the cooker off, disconnect it from the
mains for a few minutes (unlock the fuse or
switch off the main switch), then reconnect it
to the mains and set the correct daily time.
Program clock display is
flashing…
There was a power failure, or the cooker
had been connected to the mains for the first
time. All settings are erased. Set the correct
time of day to be able to activate the oven.
After operating in automatic mode, the oven
switches off, the display indicates time, and
the beep is heard. Take the food from the
oven, set the temperature selection knob
and the mode knob into their original
positions. Select the "Manual mode", and
use the oven in a conventional mode
(without programming).
Signal lamp does not turn on....
•
are all the required switches properly
activated?
•
is the mains power fuse burned?
•
is the temperature regulator properly set?
Fuses often burn out...
•
Call the serviceman or your electrician!
Oven illumination is not on....
•
Exchange of oven bulb is described in the
section "Replacement of parts".
Oven does not heat up...
•
is the mains power fuse burned?
•
is the temperature regulator set correctly?
•
did you set the oven to the conventional
mode after using it in the automatic mode
(programmed)? Switch the mode button to
the position "Manual mode".
Baking results are
disappointing...
•
did you remove the grease filter?
•
did you follow the instructions and
warnings from the section "Baking"?
•
did you strictly follow the information from
the baking table?