15
7
D
V
E
C
D
A
2
4
3
1
Clean the cone and its slot by means of a cloth soaked with diluent.
Slightly grease the cone with the relevant grease, put it in its slot,
and turn it some times. Remove the cone again, remove the
exceeding grease making sure the gas entries are not obstructed
by grease residuals. Assemble everything carefully in the opposite
direction check the connection seal by means of soapy water.
TAPS REPLACEMENT
Act as follows: open the work-top and disassemble also the control
panel as described on the previous paragraph. Unscrew screw
nut D of the gas tube supplying the burner. Unscrew screw V fixing
the tap to the bridle and remove it (see picture).
Note: Every time the tap is replaced, it is necessary to replace
the seal gasket too check the connection seal by means of soapy
water.
Fig. 51
mod.
T
ip. Montagnani - Modena -
Cod. 533829
1002
GB
Fig. 52
Fig. 53
AREA FOR CERAMIC HOB
Ø mm
WATT
HALOGEN
(1-2) 200
1700
or RADIANT
1800
RADIANT
(4) 230
1700
or RADIANT
2100
RADIANT
(3) 165
1200
INSTRUCTIONS
BOOKLET
INSTRUCTIONS
BOOKLET
GAS OVEN WITH
WATT
GRILL HEATING ELEMENT
2000
N.B.: the rapid electric plates are marked with a red dot.
ELECTRIC PLATE
Ø mm
WATT
STANDARD
(A-C) 145
1000
RAPID
(D) 180
2000
STANDARD
(E) 180
1500
AIR FORCED OVEN
WATT
GRILL ELEMENT
2000
FANNED ELEMENT
2100
MULTIFUNCIONAL OVEN
WATT
UPPER ELEMENT
850
LOWER ELEMENT
1200
GRILL ELEMENT
850+1050
FANNED ELEMENT
2100
CONVENTIONAL OVEN
WATT
UPPER ELEMENT
850
LOWER ELEMENT
1200
GRILL ELEMENT
850+1050
- To disassemble the control panel, unscrew the 3 internal screws
fixing the control panel to the oven face.
GREASING OF TAPS
If a tap becomes hard to be turned, grease it using a specific
grease withstanding high temperatures. Act as follows: open the
work-top and disassemble also the control panel as described on
the previous paragraph. Unscrew the two fixing screws from the
burner body (see picture) and remove the cone.
Fig. 50
