10
a)
Changing the LIGHT BULB
9
Disconnect the hood from the power supply.
9
Access the lamp area. Please note that you will have to take off the
grease grille at the back to access the lamp area.
9
Always replace burnt-out bulbs with olive-shaped 40 Watt bulbs.
9
After replacing the bulb, put the grease grille back.
__________
b) Changing the CARBON FILTER
You will find that one filter will attach over the front of the fan motor (please
see figure at bottom of page).
The active carbon filter must be replaced regularly, at least once every four
months, to allow normal operation when in recirculation mode.
Before starting to fit the carbon filter, turn the omni-polar switch to ‘0’.
Changing the Carbon Filter – Note: carbon filters cannot be cleaned!
1)
Remove the metal grease filter
grille (see page 9).
2)
Take carbon filter and extract
centre peg on it about 10mm. (If
changing, remove the old carbon
filter by rotating it until it
unlatches from the sides of the
motor).
3)
Place the new carbon filter over
the motor bracket, making sure
that the centre button fits exactly
into the hole on the bracket. Press
lightly until it snaps into place
then insert the centre peg.
4)
Replace the anti-grease
filter grille.
NOTE
If your filter is different (i.e.
is the Bayonet Circular-
insert type,
Position the filter P in order
to cover the motor
protection grille, ensuring
that the ‘X’ on the filter lines
up with the ‘Y’ on the
conveyor. Then turn
clockwise. Reverse to
dismount
Maintenance – Changing the Light Bulb and Carbon Filter