Baumatic BO610.5SS, Инструкция по эксплуатации, Страница: 22 / 36

o
The oven must be fitted into an oven housing with the ventilation
cut-outs shown in the “Ventilation requirements” section below.
o
Ensure that the rear panel of the furniture housing unit has been
removed.
Ventilation requirements
o
You should remove the rear panel of the housing unit before
attempting to install the oven.
o
A minimum ventilation gap of 50 mm must be allowed between
the rear of the support shelf and the rear of the housing unit.
o
A 400 cm² (20 x 20 cm) ventilation cut out must be made in the
support shelf.
o
A minimum ventilation area of 80 cm² must be allowed below
the appliance.
o
If the appliance is to be installed in a Leisure Accommodation
Vehicle, the requirements of EN 721 must be applied.
22