Baumatic BFWM1406W, Инструкция по эксплуатации, Страница: 34 / 40

If a fault code reappears after following the
above advice and clearing the fault code. You
should turn the washing machine off.
Disconnect the appliance from your mains
supply. Then arrange for an engineer to
attend the appliance. You should contact the
Baumatic Customer Care Department on
(0118) 933 6911.
IF AN ENGINEER ATTENDS DURING THE
GUARANTEE PERIOD AND FINDS THAT A FAULT
HAS BEEN CAUSED BY AN ITEM ON THE ERROR
CODE LIST, WHICH COULD HAVE BEEN CLEARED
BY THE CUSTOMER. THEN YOU MAY BE LIABLE
FOR THE COST OF THE SERVICE CALL.
General troubleshooting
34
Problem Possible solutions
The washing machine does
not work.
o
Close the washing machine’s door.
o
Confirm and press the start button.
Water leakage.
o
Correctly connect the inlet water pipe.
The spin of the clothes is
abnormal.
o
Reload and distribute the laundry evenly in the
drum.
There is a peculiar smell in
the washing machine.
o
Run a high temperature cycle without any
clothes.
No water is visible in the
drum.
o
No fault. The water is under the visible area.
There is remaining water
in the softener
compartment.
o
No fault. The effect of the softener will not be
affected.
The remaining detergent is
left on the clothes.
o
The water-fast component of the non-
phosphorus detergent left on the clothes will
cause lime scale. Select the rinse and spin
program or brush away the detergent when the
clothes are dried.
The washing machine does
not fill.
o
Open the water tap.
o
Check the selection of the program.
o
Check the water pressure to see if the water
pressure is insufficient.
o
Put through the feed-water.
o
Close the machine’s door.
o
Check if the inlet water pipe is bent or clocked.
Spinning starts late or the
machine does not spin.
o
The imbalance control system has activated
because the laundry is unevenly distributed in
the drum,
o
The appliance will redistribute the laundry by
reversing the drum rotation. This may take
several attempts before the laundry is evenly
distributed and normal spinning can resume.
o
If the laundry is still not evenly distributed after
10 minutes, the machine will not spin. In the
event of this, redistribute the load manually and
select the program again.