Baumatic BDW65S, Инструкция по эксплуатации

Страница: 32 / 44

32
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING
THE ABOVE ADVICE AND CLEARING THE FAULT
CODE. YOU SHOULD TURN OFF THE APPLIANCE;
DISCONNECT THE APPLIANCE FROM YOUR MAINS
SUPPLY. THEN ARRANGE FOR AN ENGINEER TO
ATTEND THE APPLIANCE. YOU SHOULD CONTACT
THE SERVICE DEPARTMENT ON TELEPHONE
NUMBER 1800 444 357.
IF AN ENGINEER ATTENDS DURING THE GUARANTEE
PERIOD AND FINDS THAT A FAULT HAS BEEN
CAUSED BY AN ITEM ON THE ERROR CODE LIST,
WHICH COULD HAVE BEEN CLEARED BY THE
CUSTOMER. THEN YOU MAY BE LIABLE FOR THE
COST OF THE SERVICE CALL.
General troubleshooting
PROBLEM POSSIBLE
CAUSES
WHAT TO DO
Dishwasher
does not start. Fuse has blown or
the circuit breaker
acted.
Power supply is not
turned on.
Water pressure is
low.
Dishwasher door is
not properly closed.
Replace the fuse or reset the
circuit breaker. Remove any other
appliances sharing the same
circuit with the dishwasher.
Make sure the dishwasher is
turned on and the door is closed
securely.
Make sure the power cord is
properly plugged into the wall
socket.
Check that the water supply is
connected properly and the water
is turned on.
Make sure to close the door
properly and latch it.
Water not
pumped from
the
dishwasher.
Kink in the drain
hose.
Filter is clogged.
Kitchen sink is
clogged.
Check the drain hose.
Check the filter assembly.
Check the kitchen sink to make
sure it is draining well. If the
problem is the kitchen sink not
draining, you may need a plumber
rather than an engineer for the
dishwasher.
Suds in the
tub. Improper detergent
used.
Use only specialised dishwasher
detergent to avoid suds. If this
occurs, open the dishwasher door
Downloaded from www.Manualslib.com manuals search engine