Baumatic BDI652, Инструкция по эксплуатации

Страница: 27 / 44

E4
o
The machine has sensed water in the base.
9
Check that the outlet hose is not kinked or crushed.
9
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
9
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E6
o
Open circuit
9
Thermistor
9
Call the Customer Care Department.
E7
o
Short circuit
9
Thermistor
9
Call the Customer Care Department.
o
Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o
Turn the machine on using the ON/OFF button and wait for 5
seconds.
o
Press and hold down the delay start button and the ON/OFF
button, until the appliance switches off.
o
Wait for 5 seconds, and then switch back on the appliance using
the ON/OFF button.
o
Wait for a further 5 seconds before attempting to set a wash
program, using the program selection button.
IMPORTANT: If any other fault code appears in the
display window, you should not attempt to clear it yourself
and contact the Customer Care Department.
27
SUPP
LD T
E CUSTOMER CARE DEPARTMENT ON TELEPHONE
NUMBER (0118) 933 6911.
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING
THE ABOVE ADVICE AND CLEARING THE FAULT
CODE. YOU SHOULD TURN OFF THE APPLIANCE;
DISCONNECT THE APPLIANCE FROM YOUR MAINS
LY. THEN ARRANGE FOR AN ENGINEER TO
ATTEND THE APPLIANCE. YOU SHOU CON ACT
TH