Detergent
The detergent dispenser must be refilled at the start of each wash cycle (apart from
the Rinse wash program).
Open the detergent cover and place the detergent inside the dispenser. Shut the
detergent dispenser lid and position the clip on the outer edge, so that it holds the lid
shut.
Section marked 1 is for the main wash detergent. The detergent can be a tablet, liquid or powder.
Section marked 2 is for any cycle with a pre-wash element, however this is optional. The detergent must be liquid or
powder not a detergent tablet.
Starting a wash program
1.
Load the dishwasher.
2.
Add detergent
3.
Turn the appliance on by using the ON/OFF button
4.
Press the program selection button to choose an appropriate wash program. The relevant program indicator neon
will light to show which program you have selected.
5.
Close the door firmly. The washing will start after a few seconds.
Changing the wash program
Note: this should only be attempted when the cycle has only just started, otherwise the detergent tablet may have
already released, or hot water could escape.
1.
Slightly open the door of the appliance and turn off the power using the ON/OFF button.
2.
Wait for a minute before fully opening the door of the appliance.
3.
Turn the appliance on by using the ON/OFF button and wait for 5 seconds before pressing the program button.
4.
Press and hold the program selection button for 3 seconds to cancel the wash program. Then use the program
selection button to choose the correct wash program.
5.
Close the door firmly. The washing will start after a few seconds.
At the end of a wash program
1.
The time display will flash for 8 seconds and a buzzer will sound.
2.
Open the door of the appliance.
3.
Use the ON/OFF button to switch the dishwasher off and unload.
