Baumatic BCFFU7030, Руководство пользователя

Страница: 12 / 20

Positioning and installing the appliance
1. Once the appliance has been unpacked, check the main voltage is the same as that
indicated on the rating plate.
2. If the door opening direction is as required, go to Point 2. Otherwise, reverse the
position of the hinges. To do this, carefully place the on its back, user spacers to
prevent crushing the condenser pipes and damaging the compressor unit.
2a Remove the lower hinge pin P.
2b Remove the lower hinge A and the lower door.
2c Remove the middle two hinges A and B, then free the upper door.
2d Remove the upper hinge B and fit the hinge A to the opposite side.
2e Remove the central support L.
2f Refit the central support L to the opposite side.
2g Fit the middle hinges A and B on the left side.
2h Refit the upper and lower door and related hinges.
When installing the appliance, remember the following:
A Do not install it near to sources of heat such as heaters, radiators, cookers, etc. or in
direct sunlight.
B Make sure that during the automatic defrost, any water on the back wall of the
compartment runs into the drain channel.
C After the appliance has been placed in its final position, leave it for about at least an
hour before connecting it to the power supply.
D Make sure that the appliance is working properly before placing any food in it.
WARNING: DO NOT INSTALL THE APPLIANCE NEAR TO ANY HEAT SOURCES AND
LEAVE A GAP OF AT LEAST 5 CM ABOVE IT.
INSTALLATION IN THE TALL UNIT HOUSING
The dimensions of the tall unit housing must be correspond to those reported in the figure.
2. I nsert the appliance in the housing against the side panel adjacent to the opening.
1. A djust the foot until the top panel is not in contact with the unit, and anchor the upper
part of the appliance, using the screws supplied, in the pre-drilled panel over the front
fascia.
3
. Anchor the center of the appliance to the wall of the unit using the special brackets.
4. Fix the two bottom feet in the holes in the base of the unit.
5. W here provided, apply the plastic joint gasket.
6. Anchor the part with screws on the appliance door.
7. Fit the sliding part with screws, after adjusting the housing door.
IMPORTANT: Ensure that you have ventilation for your unit, as indicated the
the technical drawing on page 10
11